You have no items in your shopping cart.
How to Install Adapter
The adapter fits in-between the air filter assembly and the carburetor. The process is similar for most engines. The engine diagram shown is a common generic design and uses stud extenders (Some Applications use other fasteners). All American / SAE type carburetor adapter kits will include two new longer studs with the kit. Instead of adding an extender, each stud is removed and a longer stud is installed to add the 1-1/4" of additional length needed. Accessories are included to extend the crank case vent tube and any additional holding bolts as needed for each specific engine type.
Basic Installation
NOTE:There are more steps to the conversion process but the following steps describe the basic process.
Step 1 - Remove the air cleaner assembly
Step 2 - Install the fuel adapter
Step 3 - Assemble fuel regulator and mount on the frame
Step 4 - Connect to barbecue tank, if applicable.
Complete installation shown with 20# propane cylinder. After the kit is installed going from gasoline to propane or natural gas is as easy as turn off the petcock on the gasoline tank and connecting a propane cylinder or using a rubber hook-up hose and quick disconnect to connect the generator into the home gas pipe system.